Witch Hat Earrings | Beads Direct
0

Witch Hat Earrings

Step 1

Take about 30 cm of your thread and thread your needle, now taking your button and loop round this and tie off. 

Step 2

Your needle and thread should still be attached to your button you need to pick up one of the Swarovski green pearls and one black seed bead and then looping round the seed bead reverse back through the pearl and through the other hole in the button until you are back at the top of the button again and pull tight.

Step 3

Now slide on your Artemis bead this will act as the witches hat, take another seed bead so it sits on top of the point of the hat and then take an ear wire and loop back down the centre of all the beads so you are back at the bottom again and all the beads are secure in place and pulled tight. You just need to tie the thread off around the black seed bead at the bottom and repeat all the steps again making the second pair of earrings.