SuperDuo Bauble Earrings - step by step jewellery making tutorial

On the thread with a length of 40-50cm we thread the sequences given in the photo. (1TR,1SD x5)

Go back through all the beads, forming a circle.

We tie a double knot and tighten it firmly. The creation of a "flower".

 We pass the needle through the beads so that the thread comes out of the bottom hole of the SuperDuo.

We pass with a needle through the upper eyelet of our bead (from the same side from which the thread comes out).

The bead from which the thread comes out belongs to our sequence. So we put the remaining beads on it (in a certain order) and pass through the SuperDuo.

We go through the added lap again, the thread itself. We will do this every time.

At the end of threading, we pass with a needle through the first bead of our lap, located just after the combination of two "flowers".

We move to the upper hole.

In the photo below, I have pointed with the needle to the gap between the two SuperDuo, in which there are 2 Toho beads. In this arrangement, we add in lap 1 toho bead between 2 SuperDuo. And we select the rest of the sequence. We pass through all the beads again (step 7-8). We pull the thread firmly.

We pierce through the upper eyelet and repeat step 10.

After the fourth lap, this is what needlework should look like. We repeat again step 10, making the fifth "flower". Do not forget to pass through all the added beads a second time, the thread itself.

This is what 5 "flowers" look like. We pass to the upper hole of the bead, from which the thread comes out. Pulling the thread, we slowly begin to form the shape of the ball.

In this agreement, we will have two breaks in a row (referred to in step 10). We add 1 Toho bead between the SuperDuo (as in the pictures) and the rest of our sequence. We pass through all the added beads again with the same thread (see step 7-9). We pull the thread firmly.

This is what 6 "flowers" look like. We repeat step 14, creating the seventh lap.

We have 7 "flowers". Again, we repeat step 14, creating lap 8.

This is what 8 "flowers" look like. We repeat step 14 until there are 3 breaks (as in the photo in step 18)

After some time of adding a lap, 3 breaks will be hit.

We are acting as before. We add one Toho bead between superduo. This time it will be 3 times, not 2.

Then we add the rest of the sequence. Remember to pull the thread quite firmly and re-thread the thread through the added beads.

In the last lap, we will be left adding only Toho beads between SuperDuo. For the whole lap we pass again with the thread itself.

At the end of the thread should come out of the toho bead.

We thread on the needle 4 beads Toho, earwire, 4 beads Toho.

We break through the bead from which the thread comes out (as in the photo).

We pass again through the added beads and earwire. 

At the end, we pass through the bead from which the thread comes out.

We pierce through several beads.

Now to tie the thread, we pass a needle under the thread located in the "flower" (right at the place from which the thread comes out).

We thread the needle through the loop.

We tighten the knot firmly.

We hide knots and thread in the beads.

We cut off the excess thread.

The tail at the beginning of the work we put on the needle and tie a knot in the same way. We cut off the excess.

I hope you liked the ball earrings and soon there will be a real ball madness. As I know your creativity, you will apply them to many projects, including those that are not earrings. Good luck! Also show off your works of art on our facebook group.