Something New Pearl Bracelet | beadsdirect.co.uk
0

Something New Pearl Bracelet

Products used in project:

Something New Pearl Bracelet

Items (10)
Qty
Price
X Sterling Silver 925 Small Charm Carrier 3x5mm(inner hole 2mm) Pk1
SS524
1
Out of stock
Beadalon 7 Strand Flexible Beading Wire 'Bright' 0.012in 30ft
W73
1
Out of stock
5810 Swarovski Crystal Pearls 8mm Crystal Iri Dove Grey Pk25
HH364
1
Out of stock
77508 Swarovski Silver Plated Rondelle 8mm Crystal Clear Pk6
AC250
1
Out of stock
X Sterling Silver 925 Crimp Beads 2mm Pk20
SS378
1
Out of stock
Sterling Silver 925 Calottes 3.5mm Pk2
SS140
1
Out of stock
X-Sterling Silver 925 Filigree Box Clasp 12x5mm Pk1
SS474
1
Out of stock
1122 Swarovski Rivoli 12mm Crystal F Pk1
AC986
1
Out of stock
Gem-Tac Embellishing Glue 5ml (0.17floz)
W481
1
Out of stock
X- Sterling Silver 925 12mm Rivoli Charm Base Pk1
SS386
1
Out of stock
Total Cost
£0.00

Not all products are available for this project

Information about project:

Something New Pearl Bracelet

Designed by: Katrina

Difficulty: Beginner

Rating:

Our beautiful 'Something New' Pearl Bracelet is the perfect accessory for a wedding or special occasion. Learn how to this classic design with NEW Swarovski dove grey crystal pearls and sterling silver findings for a truly high quality and professional finish. 

Step 1

To make a 7-inch bracelet, begin by cutting a 12-inch length of wire. Thread on a calotte and a crimp bead. Then pass the end of the wire back through the calotte, leaving a 2-inch tail. Squash the crimp bead flat and cover it with your calotte.

Step 2

Thread on your beads in the following order.

P = Pearl
R = Rondelle
CC = Carrier charm

2P, R, 3P, R, 3P, R, 2P, CC, 2P, R, 3P, R, 3P, R, 2P. 

Step 3

Check the size against your wrist and amend the pattern if necessary. Finish your wire as before, passing the end through a calotte and a crimp bead. Pass the wire back through the calotte and back through the beads. Insert a pin inside the loop of wire and pull the wire so that the calotte is flush to the end pearl and there are no gaps along the design. Squash the crimp bead flat and cover it with the calotte. 

Step 4

For each side of the bracelet, close the loop of the calotte onto the rings either side of the clasp. Open the loop of the crystal setting with your pliers and close it onto the loop of the carrier charm. Apply a drop of glue to the crystal setting, insert the Swarovski crystal and allow to fully dry (up to 24 hours) before wearing.