Silver Snowflake Kit

Bracelet 1

Thread 40 Snowflake spacers directly onto the reel of wire. They should follow the pattern 2 x Green and 2 x Silver (20 of each). Then add on the Shamballa tube. Repeat the first step to create the second half of the Snowflake pattern. Trim the wire leaving a few inches excess on each side. 

Thread a crimp bead onto one side of the excess wire followed by a Lobster clasp from the findings kit. Thread back through the crimp bead and close over the wire. Push the snowflakes up firmly and repeat on the other side (replacing the lobster clasp with a jumpring), ensuring that the crimp is closed closely to the beads.

Add an extra jumpring onto the crimped jumpring. You may wish to use pliers to close the jumprings completely by 'squashing' them flat to prevent the wire sliding out.

Bracelet 2

Thread directly onto the reel, ( N.B. all pearls used are code EX3769). Add one pearl followed by 7 gunmetal Snowflake Spacer beads. Repeat this pattern 12 times (or until you reach the desired length). Finish on a pearl.

Thread a crimp bead onto one side of the excess wire followed by a Lobster clasp from the findings kit. Thread back through the crimp bead and close over the wire. Push the snowflakes up firmly and repeat on the other side (replacing the lobster clasp with a jumpring), ensuring that the crimp is closed closely to the beads.

Add an extra jumpring onto the crimped jumpring. You may wish to use pliers to close the jumprings completely by 'squashing' them flat to prevent the wire sliding out.

Bracelet 3

Thread directly onto the reel of wire. All pearls used are EX3769. Thread 9 pearls onto the wire followed by the pattern 6 x purple Snowflake Spacers and 1 x pearl. Repeat 8 times. Add another 9 pearls to match the opposite side. (You may wish to adjust amount of pearls added to create a different desired length).

Thread a crimp bead onto one side of the excess wire followed by a Lobster clasp from the findings kit. Thread back through the crimp bead and close over the wire. Push the snowflakes up firmly and repeat on the other side (replacing the lobster clasp with a jumpring), ensuring that the crimp is closed closely to the beads.

Add an extra jumpring onto the crimped jumpring. You may wish to use pliers to close the jumprings completely by 'squashing' them flat to prevent the wire sliding out.

Necklace

Thread directly onto the reel of wire. All pearls used are EX3769. Thread on 20 small silver beads from the Findings Kit. Thread on 10 large silver beads from the kit. Add 1 x pearl and 4 x hot pink Snowflake Spacers. Repeat 11 times. Add on 10 x large silver beads and 20 small silver beads to match the opposite side.

Thread a crimp bead onto one side of the excess wire followed by a Lobster clasp from the findings kit. Thread back through the crimp bead and close over the wire. Push the snowflakes up firmly and repeat on the other side (replacing the lobster clasp with a jumpring), ensuring that the crimp is closed closely to the beads. You may wish to create an extension chain out of jumprings to attach to the crimped jumpring. To do this, simply connect approximately 8 jumprings together.

Add an extra jumpring onto the crimped jumpring. You may wish to use pliers to close the jumprings completely by 'squashing' them flat to prevent the wire sliding out.