Learn how to make these 'Rose' Bracelets from the 'Summer Flora' Collection | beadsdirect.co.uk
0

'Rose, Summer Flora' Bracelets

Products used in project:

'Rose, Summer Flora' Bracelets

Items (4)
Qty
Price
Fevi Kwik One Drop Instant Adhesive/Glue 3g Tube
W270
1
Out of stock
Gold Plated Brass Round Lobster Clasp 13mm Pk1
F990
1
Out of stock
X-Gold Plated Iron Jumprings 4mm 0.8mm Thick Pk100
F0214
1
Out of stock
Total Cost
£1.31

Not all products are available for this project

Information about project:

'Rose, Summer Flora' Bracelets

Difficulty: Beginner

Rating:

Learn how to make these 'Rose' Bracelets from the 'Summer Flora' Collection using Liberty of London Ribbon and a Swarovski Crystal.

Step 1

To make the Ribbon Wrapped Bangle-
Add a dab of Fevi Kwik glue onto the bangle base and attach the end of the ribbon to it. Hold in place for a minute, until dry. Continue to wrap the ribbon around the bangle until the bangle base is completely covered. Trim ribbon and secure tightly using Fevi Kwik.

Step 2

To make the Elastic Bead Braclet-
Thread on the desired amount of beads onto elastic (approx. 30). Trim elastic and tie securely using a double knot. You may wish to add a dab of glue to the knot for added security.

Step 3

To make the Braided Swarovski Bracelet-
Cut 3 lengths of approximately 30cm from your cord. Tie a knot close to the top. You may wish to attach this to a surface using a piece of cellotape. Begin to plait the cord until you reach the end. Knot again.

Step 4

Attach foldover ends onto both ends of the plait. Cut directly down the middle and work out how much you need to trim off to fir around your wrist (including the Swarovski setting). Attach two more foldover ends once you have finished trimming. Add the Swarovski setting and glue in your crystal.

Step 5

Attach a jumpring onto one foldover to create the clasp. Attach a jumpring and a lobster clasp to the other end.