Red Rose Fleur Bracelet

Products used in this project

Items (0)
Total Cost

Information about this project


Scroll down to add all the products you need to create the Red Rose Fleur Bracelet to your basket in one click!

You will need:
1x Silver Plated Flower Bracelet Bar [CH181]
1x 2.5mm Red Suede Cord [TC449]
1x Fevi Kwik [W311]

Please note the measurements given are based on the average woman’s wrist size. You may want to adjust the length of the cord depending on who you are making it for.

Step 1. You will need to cut 3 pieces of suede cord measuring approx. 21cm

Step 2. Place the 3 strands together and fold over and cut the ends level (DO NOT cut the looped end)

Step 3. Thread on the slider. You will see the loop form.

Step 4. Glue the trimmed ends into the open end of the bracelet bar (make sure the cord is flush before gluing it)

 Now your bracelet is ready for you to wear.

TIP. Make sure the cord is flush before gluing it in, or you can try and twist the suede for a different effect.

If you would like to buy the products to make this bracelet you can click on the 'add all products to basket' button below.