Red Daisy Fleur Bracelets Instructions | beadsdirect.co.uk
0

Red Daisy Fleur Bracelets

Products used in project:

Red Daisy Fleur Bracelets

Items (2)
Qty
Price
Fevi Kwik One Drop Instant Adhesive/Glue 1g Tube
W311
1
Out of stock
Red Round Leather 3mm Cord 5 Metres
TC541
1
Out of stock
Total Cost
£0.00

Not all products are available for this project

Information about project:

Red Daisy Fleur Bracelets

Rating:

Scroll down to add all the products you need to create the 
 'Red Daisy Fleur Bracelet' to your basket in one click!

What you will need...
1x Silver Crystal Round Bracelet Bar [CH163]
1x 2mm Red Leather Cord [TC520]
1x 3mm Red Leather Cord  [TC541]
1xFevi Kwik  [W311]

Please note the measurements given are based on the average woman’s wrist size. You may want to adjust the length of the cord depending on who you are making it for.

Step 1. You will need to cut 1 piece of 2mm round genuine leather measuring approx. 21cm

Step 2. Cut another piece of 3mm round genuine leather measuring  the same as above.

Step 3. Fold over both pieces of leather and cut the ends level (DO NOT cut the looped end). Ensure that the thinner leather sits in between the thicker leather.

Step 4. Thread on the slider. You will see the loop form.

Step 5. Glue the trimmed ends into the open end of the bracelet bar (make sure the cord is flush before gluing it)

Step 6. Hook your  looped leather around the flower on the head of the bracelet bar.

 Now your bracelet is ready for you to wear.

TIP. You can try and twist or braid the leather for  a different effect (You may need to alter the measurements if you wish to do this).

If you would like to buy the products to make this bracelet you can click on the 'add all products to basket' button below.