Purple Charm Cuff
Products used in project:
Purple Charm Cuff
Not all products are available for this project
Information about project:
Purple Charm Cuff
Difficulty: Intermediate
You will also need a pair of Punch Pliers W425 to create holes in the leather.
Step 1
Cut your strand of leather in half so it is just over 15cm long. Glue the ends into the magnetic clasp and leave to dry.
Step 2
Measure 5cm from the clasp towards the centre of the strap. From there, measure the width of the strap to find the centre. Repeat this from the other end. Punch a hole in the two spots you have measured out using punch pliers.
Step 3
Cut 5 strands of cord approx. 20cm long. Thread all 5 through one hole and tie them all together on the inside of the leather. Take the cord around the outside of the leather (randomly threading on your charms whilst doing so) and thread through the other hole. Make sure the cord is pulled tight against the leather so thatthe charms don't make it droop. Tie another over hand knot on the inside of the leather and trim any excess cord. You may wish to use glue to secure the knots.
Step 4
Glue the crystal chaton to the charm setting and leave to dry.
What our Happy Customers Have To Say
"Love it, you always have great products and offers and ideas. You are so quick as well."
Rosie
March 26th 2020
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
