Pumpkin Earrings | beadsdirect.co.uk
0

Pumpkin Earrings

Products used in project:

Pumpkin Earrings

Items (6)
Qty
Price
Staedtler Fimo Soft Polymer Clay Indian Red 56g (1.97oz)
PC5
1
Out of stock
Staedtler Fimo Effect Polymer Clay Translucent Green 56g (1.97oz)
PC46
1
Out of stock
Staedtler Fimo Soft Polymer Clay Sunflower 56g (1.97oz)
PC3
1
Out of stock
Silver Plated Chain Extension 4x57.1mm with Teardrop Pk6
F200
1
Out of stock
X Silver Plated Earwires with Coil Pk20 (10 Pairs)
F1002
1
Out of stock
X- Silver Plated Iron Headpins 50mm (2 inch) Pk100
F0039
1
Out of stock
Total Cost
£0.00

Not all products are available for this project

Information about project:

Pumpkin Earrings

Rating:

Pumpkin Earrings

Step 1.  Mix an equal amount of the yellow and red Fimo clay so that you can get 2 x 2cm orange balls (can go bigger if you like).

Step 2. Using a toothpick starting at the top going towards the bottom press a line into it. Make 5 or 6 lines round the ball.

Step 3. Then mix an equal amount of the two greens together (you only need a little amount)

Step 4. Make 2 little spaghetti shapes with one end going into a point. Curl the pointy end into a spiral and place them on the pumpkin.

Step 5. Then pierce a hole in the middle of the pumpkin with a headpin at the top. Remove the headpin and bake at 275 Degrees Celsius for 5 minutes.

Step 6. Once you have taken the pumpkins out of the oven allow to cool.  Put in a head pin, (apply glue if necessary) make a loop and attach the chain and then the ear wires  and you’re ready to wear your pumpkin earrings.