Learn how to make this Pink Charm Cuff | Beads Direct

Pink Charm Cuff

Products used in this project

Items (7)
1088 Swarovski Crystal Chaton SS39 8mm Light Rose F Pk2
Out of stock
X-Antique Silver Zamak Sweet Heart Setting Charm 15x17mm Pk1
Out of stock
X-4809 Swarovski Crystal Sweet Heart Stone 12x13mm Crystal Astral Pink F Pk1
Out of stock
X-Silver Plated Iron Jumprings 6mm 0.8mm Thick Pk100
Out of stock
Total Cost

Not all products are available for this project

Information about this project

Difficulty: Intermediate


Learn how to make this Pink Charm Cuff using Genuine Leather and Swarovski Crystal.

You will also need a pair of Punch Pliers W425 to create holes in the leather.

Step 1

Cut your strand of leather in half so it is just over 15cm long. Glue the ends  into the magnetic clasp and leave to dry.

Step 2

Measure 5cm from the clasp towards the centre of the strap. From there, measure the width of the strap to find the centre. Repeat this from the other end. Punch a hole in the two spots you have measured out using punch pliers. Attach jump rings onto your charms.

Step 3

Cut 5 strands of cord approx. 20cm long. Thread all 5 through one hole and tie them all together on the inside of the leather. Take the cord around the outside of the leather (randomly threading on your charms whilst doing so) and thread through the other hole. Make sure the cord is pulled tight against the leather so that the charms don't make it droop. Tie another over hand knot on the inside of the leather and trim any excess cord. You may wish to use glue to secure the knots.

Step 4

Glue the crystal chaton to the charm setting and leave to dry.