Pink Champagne Bracelet | Swarovski Ceralun
Products used in project:
Pink Champagne Bracelet | Swarovski Ceralun
Not all products are available for this project
Information about project:
Pink Champagne Bracelet | Swarovski Ceralun
Designed by: Katrina
Difficulty: Beginner
Learn how to make your own personalised crystal embellished bracelet using the NEW Swarovski Ceralun epoxy resin kits, your choice of Swarovski chaton mixes and the elegant settings from Nunn Design!
Step 1
Mix a small part of the Ceralun according to the instructions.
Step 2
Roll the clay into a sausage shape about the size of a 5p coin and gently press into the bezel.
Step 3
Using the flat pad of your finger, gently tap and press the clay evenly until it reaches the edges of the bezel.
Step 4
Continue to smooth the piece, creating a flat & even surface.
Step 5
Choose your Swarovski crystals and begin to press them into the clay. Make sure the back of the crystal is completely submerged below the clay so that the line edge fits flush to the clay.
Step 6
Once your pattern is complete, dampen a cotton bud and gently wipe it across the surface of the clay for a soft shine.
Step 7
After the clay has fully hardened (up to 72 hours) open the links of the bracelet at the middle point and attach the finished bezel piece by closing the links of the chain. If the bracelet is too big, simple remove a couple of the links.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
