Penelope Pearl Bracelet
Products used in project:
Penelope Pearl Bracelet
Not all products are available for this project
Step 1
Cut an armspan of illusion cord and thread a jumpring to the centre point. Make sure the jumpring is closed securely.
Thread a crimp bead onto the two ends of cord, bringing them together and securing the jumpring. Squash the crimp bead leaving 1mm of movement for the jumpring.
Step 2
Thread a light grey pearl bead onto the two strands of illusion cord. Thread one gunmetal shell pearl onto each of the strands, separating them.
Thread a light grey pearl onto the two strands of cord, bringing them together again.
Repeat this pattern until your bracelet is the length you require.
Keep the tension so that the bracelet isn't too loose.
Step 3
To finish your bracelet, end with both cords through a light grey pearl.
Thread through a crimp bead, through a jumpring and back through the crimp and into the pearl.
Pull the cords through the pearl to tighten and bring the jumpring closer to the bracelet.
Squash the crimp bead to secure your bracelet. Trim your excess cord and hide the ends in the light grey pearl.
Finally, attach a lobster clasp to your jumpring.
What our Happy Customers Have To Say
"Love it, you always have great products and offers and ideas. You are so quick as well."
Rosie
March 26th 2020
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
