Pearl Wrapped Rings
Products used in this project
Not all products are available for this project
You may also need
Information about this project
Designed by: Claire Broom
Difficulty: Intermediate
Learn how to make these lovely wire wrapped rings using the Swarovski Iridescent Tahitian Look Pearls.
Step 1
Single Pearl Ring
Create a round ring shape doubling up your 0.8 mm wire and using the 0.4 mm start wrapping the wire around your ring base. Attach your 8 mm Swarovski pearl at the top using 0.4 mm wire again and to secure it in place start wrapping around the base of the pearl until you have built up enough wire at the base.
Step 2
Small Pearl Ring
Create a round ring shape doubling up your 0.8 mm wire. Now at one half at the top start wrapping a small amount of the 0.4 mm wire and add a 2 mm pearl securing underneath each time. Now add a 4 mm pearl to your wire strand and secure underneath - keep repeating this until the top of your ring is covered in a bubble like look.
Step 3
Single 8 mm Pearl Ring
Create a round ring shape doubling up your 0.8 mm wire. Similar to the second ring start wrapping one pearl onto the base at a time, switch between the 2 mm and 4 mm pearls and in the centre add a 8 mm pearl before switching back to the 2 and 4 mm's.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
