Learn how to make this Pearl bracelet. | Beads Direct

Pearl Bracelet

Information about this project

Difficulty: Expert


This design is now in our inspirations archive. As this design was created some time ago we sadly no longer stock all the products to create our design, but can still be useful for inspiration.

To make this bracelet you need 2 sizes of pearl that we no longer stock (as freshwater pearls are natural so we can’t always obtain exact replacements) so you could use Swarovski pearls to create a similar effect. Try HH93 for the larger pearls and HH51 for the smaller ones. We are also currently out of the roses.

Step 1

 Cut 2 x 40cm pieces of wire and attach to a clasp using a crimp bead.

Step 2

Thread 4 large pearls, followed by a large crystal on to one wire. Repeat this pattern until your bracelet reaches your desired length.

Step 3

Take the second wire and add the following: 2 small pearls, a small crystal, 2 small pearls, a small crystal, 2 small pearls, a small crystal and 2 small pearls.

Step 4

 Now thread this wire through the large crystal, and pull tight until the beads meet. Now repeat step 3 until you get all the way around the bracelet.

Step 5

Attach both wires to the other side of the clasp using a crimp to secure. Cut off any excess wire.

Step 6

Thread a headpin through the hole on a rose and make a loop to attach around the bracelet. Add one rose to either side of each large crystal.