Orange Charm Cuff
Products used in this project
Not all products are available for this project
Information about this project
You will also need a pair of Punch Pliers W425 to create holes in the leather.
Cut your strand of leather in half so it is just over 15cm long. Glue the ends into the magnetic clasp and leave to dry.
Measure 5cm from the clasp towards the centre of the strap. From there, measure the width of the strap to find the centre. Repeat this from the other end. Punch a hole in the two spots you have measured out using punch pliers. Attach jump rings onto your charms.
Cut 5 strands of cord approx. 20cm long. Thread all 5 through one hole and tie them all together on the inside of the leather. Take the cord around the outside of the leather (randomly threading on your charms whilst doing so) and thread through the other hole. Make sure the cord is pulled tight against the leather so that the charms don't make it droop. Tie another over hand knot on the inside of the leather and trim any excess cord. You may wish to use glue to secure the knots.
Glue the crystal chaton to the charm setting and leave to dry.
What our Happy Customers Have To Say
"Well done team. Customer service doesn't get any better than this."
April 22nd 2019
"Wow what service"
January 24th 2019
"I love Beads Direct."
January 21st 2019