Night Sky Ring | Swarovski Ceralun
Products used in project:
Night Sky Ring | Swarovski Ceralun
Not all products are available for this project
Information about project:
Night Sky Ring | Swarovski Ceralun
Designed by: Laura
Difficulty: Beginner
Learn how to make your own personalised Swarovski ring using the NEW Swarovski Ceralun epoxy resin, your favourite crystal chatons and a chunky ring base by Nunn Design!
Step 1
Mix a small part of the Ceralun according to the instructions. The amount of clay you need will depend on how raised you want the finish to be.
Step 2
Roll the clay into a ball and gently press into the middle of the circular ring setting.
Step 3
Using the flat pad of your finger, gently tap and press the clay evenly until it reaches the edges of the ring.
Continue to smoothen the piece, creating a flat & even surface.
Step 4
Decide on what design or pattern you want to achieve, choose your Swarovski crystals and begin to press them evenly into the clay. Make sure the back of the crystal is completely submerged below the clay so that the line edge fits flush to the clay.
Step 5
Once your pattern is complete, dampen a cotton bud and gently wipe it across the surface of the clay for a soft shine.
After the clay has fully hardened (up to 72 hours) your ring should be ready to wear!
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
