nstructions on how to make this Nautical grey and navy Sale bracelet | beadsdirect.co.uk

Nautical Grey and Navy Sale Bracelet

Products used in project:

Nautical Grey and Navy Sale Bracelet

Items (2)
Fevi Kwik One Drop Instant Adhesive/Glue 2g Tube
Out of stock
X-Silver Plated Iron Jumprings 7mm 0.8mm Thick Pk100
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Nautical Grey and Navy Sale Bracelet

Difficulty: Intermediate


Follow the tutorial to make this Nautical red and white Sale bracelet, using rayon cord.

Step 1

Step 1.

You will need to sellotape the rayon cord before cutting it otherwise it will unravel itself. Measure 21cm and place the tape around it half a cenirmeter in and then cut the rayon cord.

Step 2

This is where it gets a little tricky- Get your two end pieces form your cord and carefully take the tape off.  Hold it tight so it doesn't unravel (if you struggle trim it so that there is 5mm if tape left on). 

Step 3

You need to add a couple of drops of fevi kwik to the inside of the clasp (use it sparingly as this glue is extra strong). Push your pieces of rayon cord into one end of the clasp.

Step 4

Repeat steps 2 and 3 to make the half of your bracelet. 

Step 5

Add 2 jumping’s to the bar part of the toggle clasp and 1 to the ring part of the toggle clasp and attach to either end.

Step 6

Follow the diagrams to interlock and complete you bracelet. 

 Click HERE or on the image for a larger view.