Medusa Bracelet Stack

Cut a length of flat leather measuring 1" less than your wrist size. Attach a jumpring to each end by piercing through the leather.

To pierce holes in your leather, you can use the Rivet Piercing and Setting Tool or a craft knife to carefully make the holes.
Pierce 5 holes equal distances apart (approx 1" apart) with one at the centre of the cord. Screw and attach your rivet pyramids along your leather.

Attach another jumpring to each of the rings at the end of your cord.
Finally attach your lobster clasp using another jumpring.

Cut 4 x 1" sections of flat leather. 
Take 5 Swarovski bicones and thread each onto individual eyepins. Trim and loop the eyepin to secure the bicone in place. 
Pierce a hole on each end of the 4 pieces of leather.
Attach jumprings to each hole and link them together with the bicones on eyepins. 
On one side of your bracelet, attach a lobster clasp using a jumpring.
Attach a jumpring to the other end of the bracelet. 

For your third bracelet, take 6 agate coin beads and thread them onto 6 eyepins. Trim and loop to secure the beads.
Connect them together with jumprings to form a chain.
Create 2 bicone charms by threading a bicone onto an eyepin then trimming and creating a loop above the bead. 
At one end of the bracelet, add a bicone charm
To the other end, add a final jumpring and attach a lobster clasp.
Add another bicone charm to this jumpring.