Instructions on how to make this Renaissance style Bracelet using 3mm leather featuring a silver buc |

Masolino Renaissance Bracelet

Products used in project:

Masolino Renaissance Bracelet

Items (3)
Fevi Kwik One Drop Instant Adhesive/Glue 1g Tube
Out of stock
Dark Purple Round Leather 3mm Cord 5 Metres
Out of stock
Silver Plated Barrel End Cap for 6mm Cord 7x12mm Pk2
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Masolino Renaissance Bracelet

Designed by: Laura


What you will need:

1x Barrel End Cap [F929]
1x Magnetic Clasp [F1064]
1x Silver Slider Buckle [F863]
1x 3mm Purple Round Leather [TC593]
1x Jump Rings [F1092]

1x Fevi Kwik Glue [W311]

Step 1. Cut two pieces of leather that both measure approx. 30cm in length.

Step 2. Take one piece of leather and thread it through the centre of the slider

Step 3. Wrap the leather around the centre of the slider and adjust so the two ends are the same length.

Step 4. Tie an over hand knot and tighten the knot so it sits next to the two wraps of leather.

Step 5. Repeat on the other side of the slider using the other piece of leather.

Step 6. Trim the ends of the leather so they are even and the correct fit for your wrist.

 Step 7. Glue a barrel end to each piece.

 Step 8. Use jewellery pliers to attach the jump rings and clasp to the barrel ends.