Love Stamped Macramé Bracelet |

Love Stamped Macramé Bracelet

Products used in project:

Love Stamped Macramé Bracelet

Items (6)
Fevi Kwik One Drop Instant Adhesive/Glue 2g Tube
Out of stock
ImpressArt Stamping Hammer 9x15cm Pk1
Out of stock
ImpressArt Small Stamp Block 5x5x5cm Pk1
Out of stock
ImpressArt A Simple Strike Jig 47x50mm Heart 3mm Pk1
Out of stock
ImpressArt Jewellery 1.6mm Hole Punch 15cm Pk1
Out of stock
ImpressArt Aluminum Metal Stamping Blank Heart Tag 21x18mm Pk20
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Love Stamped Macramé Bracelet

Designed by: Katrina

Difficulty: Beginner


Make a cute and simple heart stamped Macramé bracelet using the new stamping range from ImpressArt! 

Step 1

Follow the steps on the free project sheet to learn how to make your stamped charm.

Step 2

Use the hole making pliers to cut out a small hole either side of the heart to turn it into a connector.

Step 3

Cut 2 x 30cm length strands and 2 x 1 meter length strands.

Step 4

Thread the 30cm length of cord through a hole on your charm to its halfway point and thread the other 30cm length through the other side of the charm to the halfway point.

Step 5

Choose one side of your charm and secure those threads to a work surface so that the cords stay taught. Bring the two threads together as they will act as one thread running through the centre of the knots. Thread one of your longer lengths of thread under both the cords to the halfway point. Tie a normal overhand knot at the base of the 30cm thread close to the charm. 

Step 6

Start your macrame knotting by following these images.

- Take your right hand cord and pass it over the middle two cords.
- Next, take your left hand cord and place it over the right cord. Move the left cord under the centre cord and up through the middle of the loop on the right side.
- Pull the threads to finish one half of your knot.
- Repeat this process on the opposite side by starting by crossing the left hand cord over the middle cords. 

Step 7

Create approx. 2" of knotted cord. 

Repeat this on the other side of your charm.

Step 8

Take the 4 ends of the centre cords, lay them side by side and then do a macramé braid (approx. 6 or 7 square knots) for your sliding knot.

Secure the ends with a drop of glue, being careful not to glue the sliding knot to the centre cords running through it (otherwise it will not be able to slide and adjust). Try gently pulling the centre cords through the sliding knot while the glue dries. 

Thread a seed bead onto each of the 4 threads, tie a knot and trim the ends.