Learn how to make this Liberty Plait Bracelet | beadsdirect.co.uk

Liberty Plait Bracelet

Products used in project:

Liberty Plait Bracelet

Items (2)
Fevi Kwik One Drop Instant Adhesive/Glue 1g Tube
Out of stock
Antique Silver Zamak Magnetic Flat Clasp 6x2mm 10x22mm Pk1
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Liberty Plait Bracelet

Difficulty: Beginner


Learn how to make this Liberty Plait Bracelet using Liberty of London ribbon and a pretty silver slider bead.

Step 1

Cut 3 lengths of ribbon measuring 5cm longer than the measurement of your wrist. 

Step 2

Glue one end of each of these ribbons into one side of your magnetic clasp. 

Step 3

Plait the ribbons quite tightly together
Check the bracelet will fit your wrist.
If it is too short you may need to loosen your plait to lengthen it. If it will be too long, you can create a tighter plait or trim the ends.

Step 4

Before gluing the other ends into your clasp, thread on your slider bead to the centre of the bracelet.

Glue your ribbon ends into the other side of the magnetic clasp.