Lacey Agate Bracelet
Products used in project:
Lacey Agate Bracelet
Not all products are available for this project
Information about project:
Lacey Agate Bracelet
Designed by: Vicki
Difficulty: Beginner
Step 1
Cut x12 pieces of S-LON cord approx. 40cm long.
Step 2
Take the first piece and tie to one of the small holes on the edge of the connector, knot a couple of times and trim.
Step 3
Thread x20 beads randomly onto the thread and tie a knot.
Step 4
Repeat steps 3 and 4 until all x12 threads have x20 beads on.
Step 5
Cut a x2 pieces of thread approx. 40cm. you will use these as double thread to create a stronger sliding knot.
Step 6
Cross one sides end threads with the other side and tie on the previously cut double thread, so you have equal lengths either side.
Step 7
Create the sliding knot by doing x6 complete macramé knots.
Step 8
Knot the ends on the underside of the bracelet and trim. You may want to add a dab of glue to secure.
Step 9
Thread x2 beads on to two strands together and knot, leaving a length long enough to get your bracelet on and off.
Step 10
Repeat step 9 until all strands have beads. You will have three stands on either side.
Step 11
Your bracelet is now ready to wear.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
