Jet Orbit Bracelet
Products used in project:
Jet Orbit Bracelet
Not all products are available for this project
Step 1
Take your leather and fold in half. Cut it so that the doubled length fits around half of your wrist. (You can slot the cut ends of leather into the bracelet bar back to test the length.)
Step 2
When you are happy with the length of the leather, glue in the cut ends to the back side of the bracelet bar. They should be flat on top of each other.
Step 3
Once the glue has dried, pinch together the leather at the free end and slide on the chaton setting slider. Use a small drop of FeviKwik to secure your SWAROVSKI crystal onto it.
Step 4
Hook the loop of the leather onto the bracelet bar (the sparkly setting). From there, pull the chaton setting as close to the sparkly part of the bracelet bar as you can.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
