Products used in project:
Not all products are available for this project
Cut approximately 30cms of wire and coil into a tight swirl from one end. Begin to loosely wrap this around your Barrel Agate bead and swirl tightly again at the top to create your 'cage', leaving a small loop. Trim the wire if needed. Add a jumpring to the top of the cage, or two if required.
Cut approximately 40cms of cupchain. Attach your pendant using the jumpring to the centre point of the cupchain. Use cupchain ends and a toggle clasp/jumprings to finish off your necklace.
What our Happy Customers Have To Say
"Love it, you always have great products and offers and ideas. You are so quick as well."
March 26th 2020
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
September 25th 2019