How to make a Ginko beads bracelet. | Projects | Beads Direct
0

Europe's no.1 beading & jewellery making supplier

How to make a Ginko beads bracelet.

Information about this project

Designed by: Alicja Czapla

Difficulty: Beginner

Rating:

Alicja will show you how to make a Ginko beads bracelet. They are extremely graceful beads that give many great possibilities. Alicja shares with you a simple but very effective pattern. Let's fall in love with Ginko beads ♡

If you want to make a beaded bracelet then you will need:

ginko beads (about 59 -62pcs)

- beads about 3mm - I used Crystalove beads, but that can also be TOHO, Firepolish or small natural stones,

jump rings 8 - 10mm,

- 10mm clasp,

- two needles,

- beading thread - I recommend KO or fireline,

- sharp scissors,

 - pliers to mount the clasp.

Step 1

Cut the thread and thread the needles on both ends. On one of them, thread 3 beads (in my case they are CrystaLove) and add a jump ring. 

Step 1

Step 2

Step 2

Thread a ginko bead on each needle -  thread only through one hole. Then, through each needle, thread one bead, as shown in the picture.

Step 1

Step 2

Step 3

Step 4

Step 3

Thread beads as in step 2, i.e. alternately two and one, until you get the length that suits you. Attention! At the end, there must be two beads.

Step 1

Step 2

Step 3

Step 4

Step 4

To finish our bracelet thread three small beads and a jump ring on one of the needles. Go through a ginko bead located next to the one from thread with 3mm beads come out , and the next one as it can be seen in the picture. Go through the beads marked on the picture again, make a knot and hide it between beads. Cut the ends of the thread and assemble the clasp.

Step 1

Step 2

Step 3

Step 5

Our bracelet is ready. Simple and fast, true ?? I hope you enjoy the course. If you have any questions, feel free to ask on our Facebook group

Step 1

Step 2