Hematite Swarovski Pearl Bracelet | Beads Direct
0

Swarovski Pearl Bracelet made with Swarovski

Information about this project

Designed by: Kara-May

Difficulty: Intermediate

Rating:

Learn how to make this stunning bracelet using Swarovski pearls and seed beads. Gorgeous statement piece for the holiday season. 

Step 1

Cut roughly 80 cm of thread and through your size 10 needle, you will need two needles. Now thread on one size 10 Swarovski pearl leaving half the thread hanging out the other side, through on seed bead loop over and thread back through your Swarovski pearl so both pieces of thread are hanging down under the pearl. You will now need a needle threaded onto the other piece of thread. 

Step 1

Step 2

With both needles, thread a seed bead onto both of them securing the Swarovski pearl in place. Now on each thread separately thread four seed beads. add a size 6 Swarovski pearl to one length and using the other length thread through the other size so the threads swap in the centre. 

Step 1

Step 3

Now add six seed beads to each thread and repeat the last step with the size 6 Swarovski pearl. This step needs to be repeated eight more times, less if you have a smaller wrist or more if you have a larger wrist. Once you have completed this add four seed beads to each thread and a single one to meet the two in the centre like on step one. Once out the other side add seven seed beads to both pieces of thread and you are going to cross over the threads and go back down the other sides creating a loop of beads that will fit over the size 10 pearl to create a clasp. 

Step 1

Step 2

Step 4

Now you can go back in by going down each side of the seed beads until you meet the fifth seed bead on the bracelet design, you then need to add a size 6 pearl each side and cross these over which will create two pearls sitting next to each other, thread back through the next seed bead nearest the centre pearl and repeat the process before until you reach the other end again, you need to then tie off in small knots down the bracelet threading through a seed bead at a time until secure, cut the thread and you are finished. 

Step 1