Heavy Metal Twisting Bracelet
Products used in this project
Not all products are available for this project
The finished bracelet is approx. 8" long when it is finished, you may want to include less beads for a snugger bracelet for smaller wrists.
Cut 5 lengths of approx. 6.5" of wire.
Attach one end of each to the loops on the rose gold fancy bar clasp using crimp beads.
Thread on approx. 40 of the Miyuki square 4mm beads in gold onto one wire.
Thread the same amount of the Miyuki square 4mm metallic dark gold onto another wire.
Thread the same amount of the Miyuki square 4mm metallic hematite onto a third wire.
Thread on approx. 35-37 of the bronze and silver metatite cube beads onto the last two strands.
You may want to add these slightly larger cubes to the 2nd and 4th wires on the fancy bar clasp to evenly spread out the sizes.
Finish each strand by securing it to the second fancy bar clasps loops, using crimp beads. Trim off any excess wire.
Make sure the beads on the wires aren't too close together, so the bracelet has movement.
Lay your bracelet with the patterned side of the fancy bar clasp facing up.
Twist one end of the bracelet around until the patterned side of the fancy bar clasp is facing you again.
Attach your toggle clasp to the bracelet while it is in this position (using jumprings).
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
September 25th 2019
August 13th 2019