Instructions on how to make a gunmetal bead with skull shamballa fashion bracelet. |

Gunmetal Shamballa Fashion Bead and Skull Bracelet

Products used in project:

Gunmetal Shamballa Fashion Bead and Skull Bracelet

Items (1)
"X" Silver Hematite Beads 10mm Round Pk10
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Gunmetal Shamballa Fashion Bead and Skull Bracelet

Designed by: Laura


What you will need... 

1x Grey Waxed Nylon Cord 1mm [TC345]
1x Silver Hematite 8mm [EX47]
1x Silver Hematite 10mm [EX48]
1x Gunmetal 10mm Essential Shamballa Fashion Bead [MBJ05]
1x Black Skull with Gunmetal Czech Crystal [MB271]

STEP 1: Cut approx. 40cm of the Shamballa cord an tie a knot at one end, then tie another knot approx. 10cm below that.

STEP 2: Cut approx. 1m more Shamballa cord and start your square knots. Do two complete macramé square knots and thread on a bead. If you have not tied a square knot before please watch our tutorial video.

STEP 3: Do two complete knots, knotting around the bead. Now thread on another bead and tie two complete knots. Continue adding the beads until all 9 have been added.

STEP 4: Do two complete knots and then knot or burn with a thread zapper. Leave a 10cm gap and then tie a knot, trim any excess cord.

STEP 5: Cut approx. 60cm of cord and create a sliding knot over the base cords. Trim any excess cords by either knotting them or using a thread zapper.