Gold and Red Wrap Enchanted Jewels Bracelet |

Gold and Red Wrap Bracelet

Products used in project:

Gold and Red Wrap Bracelet

Items (1)
Black Round Leather 2mm Cord 5metre Reel
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Gold and Red Wrap Bracelet

Designed by: Laura

Difficulty: Intermediate


Take your 'Take a Make Break' design one step further with the Leather Wrap Enchanted Jewels Bracelet.

Step 1

Cut approx. 90cm worth of leather, fold this in half and tie a knot. The loop you have created needs to be big enough to fit the Zamak Button.

Step 2

(Pic 2)
Using approx. 1 metre of shamballa fashion cord (nylon waxed cord) thread it through the centre of the 2 leather strands and tie a knot (you should now have 2 strands of shamballa fashion cord measuring about the same length)

Step 3

Thread the right hand side shamballa fashion cord OVER the first leather strand and UNDER the second leather cord.

Step 4

Pick up the original left hand side shamballa fashion cord  and thread OVER the nearest strand of leather and UNDER the furthest strand of leather.

Step 5

Repeat Step 2 another 7 times.

Step 6

Place the cup chain beneath the shamballa fashion cord

Step 7

Thread the right hand cord diagonally across the inside of the cupchain. Thread the left hand cord diagonally in the opposite direction through the cupchain.

Step 8

Your now, right hand cord needs to go OVER the right leather cord, UNDER the cupchain and UNDER the left cord.

(next image >>) Please click on the >> in the picture to see addtional photo

Move on to the cord you haven't used and go OVER the left strand of leather, OVER the cupchain and UNDER the furthest right strand of leather. You have now completed a full knot.

Step 9

Continue to loop your shamballa fashion cord under and over the leather cords.

Step 10

Repeat step 9 until you are happy with the length of your bracelet.

Step 11

Replicate this technique by following Step 2.

Step 12

Thread both pieces of cord through the button and tie a knot.

Step 13

Place a Swarovski Elements Chaton into the first cup of the bracelet setting. When in place, use pliers to close the teeth on the setting. Repeat until you have added a crystal chaton to each setting cup.

Step 14

Glue the cord ends on to the leather cord.