Glitter Rock Pink Bracelets
Products used in project:
Glitter Rock Pink Bracelets
Not all products are available for this project
Information about project:
Glitter Rock Pink Bracelets
Difficulty: Intermediate
Please note: You may also wish to purchase the regaliz cutter to complete this project if you don't already have one.
Step 1
Cupchain Glitter Rock Bracelet
Cut the leather to fit your wrist allowing for the clasp. Cut the cupchain to the same length.
Step 2
Open the groove in the leather using pliers. Place in the cupchain. It is quite a tight fit!
Step 3
Glue on the ends and leave to dry. Attach the clasp to one end using a jump ring. Add two jump rings and an extender chain to the other. Use a jumpring to add a charm to the extender chain.
Step 4
Owlet Glitter Rock Bracelet
Cut the leather to fit your wrist allowing for the clasp. Cut 2 pieces of waxed cotton cord approx. 20cm long.
Step 5
Loop a piece of waxed cotton cord through each hole in the owlet stone. Position in the middle of the leather and thread 3 oval rings over each side.
Step 6
Cut the waxed cotton to match the length of the leather. Glue on the ends and leave to dry. Attach the clasp to one end using a jump ring. Add two jump rings and an extender chain to the other. Use a jump ring to add a charm to the extender chain.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
