Glistening Sea Necklace | Swarovski Ceralun |

Glistening Sea Necklace | Swarovski Ceralun

Products used in project:

Glistening Sea Necklace | Swarovski Ceralun

Items (7)
5328 Swarovski Crystal Bicones Xillion 4mm Indicolite Pk24
Out of stock
X-Silver Plated Brass Eyepins 50mm (2 inch) Pk100
Out of stock
X-Silver Plated Heart Shape Lobster Clasp 7x10mm Pk5
Out of stock
X Nunn Design Antique Silver Shell Charm 15x18mm Pk1
Out of stock
5328 Swarovski Crystal Bicone Beads 4mm Majestic Blue Pk24
Out of stock
Silver Plated Jump Rings 4mm 0.8mm Pk50
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Glistening Sea Necklace | Swarovski Ceralun

Designed by: Katrina

Difficulty: Beginner


Learn how to make your own sparkling necklace using the NEW Swarovski Ceralun and your favourite crystal chaton mixes!

Step 1

Mix a small part of the Ceralun according to the instructions. The amount of clay you need will depend on how raised you want the finish to be.  To make a domed piece as pictured, you will need a (mixed) ball about the size of a 20p coin.

Step 2

Roll the clay into a ball and gently press into the middle of the circular bezel.

Step 3

Using the flat pad of your finger, gently tap and press the clay evenly until it reaches the edges of the bezel.

Step 4

Continue to smoothen the piece, creating a flat & even surface.

Step 5

Decide on what design or pattern you want to achieve, choose your Swarovski crystals and begin to press them evenly into the clay. Make sure the back of the crystal is completely submerged below the clay so that the line edge fits flush to the clay. 

Step 6

Once your pattern is complete, dampen a cotton bud and gently wipe it across the surface of the clay for a soft shine. 

Step 7

After the clay has fully hardened (up to 72 hours) thread the pendant onto a length of chain and attach a clasp to the end using jumprings. 

Step 8

At different intervals down your necklace attach your shell charms using jumprings. 

Step 9

Take an eyepin and thread on 3 of your Swarovski bicone beads. Trim and loop the eyepin.
Create 4 of these eyepins and attach them at intervals down your necklace. To do this, cut or open a link in your chain and attach the eyepin into the gap.