Frosted Purple Necklace
Products used in this project
Not all products are available for this project
Cut three strands of tiger tail approx. 80cm long
Attach the magnet with a crimp bead
Thread on three 8mm pearl beads followed by one 8mm bicone crystal onto all three strands.
Repeat this until you have four bicones
You will now need to attach one of the cones at this stage. Starting from the one hole end put all three strands in directing one strand into one whole of the other two strands through the other hole.
To keep this in place attach a crimp bead on all three strands of tiger tail as close as you can to the middle of the two holes of the cone.
Take two strands of tiger tail and thread on a bicone crystal, leaving the other strand to one side, take the bicone down to near the silver spacer bead but leave a small gap.
Take the other strand of tiger tail and one of the strands of tiger tail which is coming out of the bicone and thread on lilac pearl bead, taking it down the tiger tail but leaving a gap of your choice.
Continue alternating between pearls and bicones crystal, I did this until I had 17 beads in total, but this can be adjusted up or down depending on how long you would like the finished necklace to be.
Before adding the other cone, crimp all the strands in one crimp bead.
Attach the cone put two threads in one hole and one thread in the other hole, directing all three strands out of the hole at the other side of the cone.
Then put on one bicone on all three strands, three pearls and repeat another three times.
Attach the other half of the magnetic clasp using a crimp bead.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
September 25th 2019
August 13th 2019