Learn how to make the Fluorite Bliss Bracelets | Beads Direct

Fluorite Bliss Bracelets

Products used in this project

Items (7)
X-Rose Gold Plated Zamak Flat Round Crystal Charm 15mm Pk1
Out of stock
X-Rose Gold Plated Zamak Bracelet Half Bar 7x45mm Pk2
Out of stock
X- Rose Gold Plated Brass Acorn Charm 9mm Pk1
Out of stock
Total Cost

Not all products are available for this project

Information about this project

Designed by: Vicki

Difficulty: Beginner


Learn how to make the Fluorite Bliss Bracelets using delicate rose gold charms, bracelet bases and pretty fluorite gemstone beads.

Step 1

Take 6 of your fluorite beads and thread them each onto individual headpins. Trim and loop above each bead. 
Attach these onto your bangle base using jumprings. 
Attach your acorn, disk and bee charm to the bangle in the same way. 

Step 2

Thread 4 fluorite beads onto a headpin. 
Cut off the nail end of the pin and loop each end.
Attach a jumpring to either side of this pin.
Take your two rose gold bangle halves, and connect them together using the jumprings on the beaded pin. 

Step 3

Cut a length of cord measuring approx. 10".
Thread this through the two remaining loops on the rose gold bangle sides. 
Cross the cords back towards each other. 

Step 4

Take the 2 ends of the cords, lay them side by side with the other part of cord stretching between the loops.  
Do a macramé braid (approx. 6 or 7 square knots) for your sliding knot.
(CLICK HERE to learn how to make macrame knots)
Secure the ends of your working cord with a drop of glue, being careful not to glue the sliding knot to the centre cords running through it (otherwise it will not be able to slide and adjust). Try gently pulling the centre cords through the sliding knot while the glue dries.
Trim the ends so the sliding knot is neat.

Step 5

Take your two tails of cord and thread a fluorite bead onto each. 
Knot below the beads.