Make Floral Fusion Shamballa Fashion Flowers featured in SS 12 catalogue |

Floral Fusion Shamballa Fashion Flowers

Products used in project:

Floral Fusion Shamballa Fashion Flowers

Items (2)
Fevi Kwik One Drop Instant Adhesive/Glue 2g Tube
Out of stock
X Silver Plated Copper Wire 0.5mm 24gauge 25metres
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Floral Fusion Shamballa Fashion Flowers

Difficulty: Intermediate


This design is now in our inspirations archive. As this design was created some time ago we sadly no longer stock all the products to create our design, but can still be useful for inspiration.

Step 1

Shamballa Fashion oval flower:

Cut 6 x 10cm lengths of wire. Use round nosed pliers to curl the end of each wire (leaving one uncurled for the centre of the flower). Thread a bead onto each wire so it stops at the curl you made. For the centre, glue on a half-drilled bead using Fevi Kwik glue. Place all wires for the flower you are working on together, with the beads at the top. Twist together to secure, and move the petals if necessary. Wind the ends of wire around a pen or pencil to create a loop and wrap the ends back around the base. Cut off any excess wire

Step 2

Shamballa Fashion heart flower:

Cut 5 x 15cm wire and 1 x 10cm wire. Thread a shamballa style heart onto a 15cm wire and position in the centre. Bring the wire down to meet at the point at the bottom of the heart and twist the two ends together. Repeat to create the 5 petals. Take the 10cm wire and glue a half-drilled bead onto the end. When dry, position this in the centre with the petal beads around it. Hold all the wires together just under the beads and twist together. Create a loop as in Step 1.