Esmeralda Bracelet
Products used in this project
Not all products are available for this project
Step 1
Open approx. 21 large jump rings, attach a hammered disk to each and close.
Step 2
Open a small jump ring and attach the extender chain. Cut approx. 30cm of wire and use a crimp to attach to the small jump ring. Thread on 2 pearls, then a jump ring with a hammered disk. Add one pearl then another disk, mixing the small and large disks as you go. Continue in this way until your bracelet reaches your desired length.
Step 3
Finish with 2 pearls and then crimp to a bolt ring to secure. Cut off any excess wire.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
