Equestrian Elegance Olive Bracelet
Products used in project:
Equestrian Elegance Olive Bracelet
Not all products are available for this project
Step 1
Trim 3x 15cm lengths of 3mm cord (2x 1 colour and 1 of the other). Loop the cord through the one loop on the connector (make sure the back of the connector is facing you).
Step 2
Loop over the connector with about 3.5cm length of cord.
Step 3
Cut a 30cm length of 1mm cord and lay a large loop over the 6 strands.
Step 4
Start wraping around all 6x 3mm strands and the 1mm cord as shown in the image.
Step 5
Wrap around 7 times.
Step 6
Slip the end through the loop.
Step 7
Pulling from the bottom pull the loop tight(you can add a dab of glue for extra security).
Step 8
Trim the ends of the 1mm cord.
Step 9
Trim the 3 shorter ends of 3mm cord (this should be the under side of the bracelet).
DO NOT ALL 6.
Step 10
Repeat steps 1-9 on the other side, but this time Trim 3x 45cm legnths of 3mm cord (2x 1 colour and 1 of the other).
Step 11
Trim the leather to fit your wrist and glue into clasp.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
