0

Equestrian Elegance Mulberry Bracelet

Information about this project

Difficulty: Intermediate

Rating:

Follow the instructions on how to make this 'Equestrian Elegance Mulberry' bracelet, using round leather and light gold large loop connector.

Step 1

Trim 3x 10cm lengths of 3mm cord (2x 1 colour and 1 of the other). Loop the cord through the one loop on the connector (make sure the back of the connector is facing you).

Step 2

Loop over the connector with about 3.5cm length of cord.

Step 3

Cut a 30cm length of 1mm cord and lay a large loop over the 6 strands.

Step 4

Start wrapping around all the 63mm strands and the 1mm cord as shown in the image.

Step 5

Wrap around 7 times.

Step 6

Slip the end through the loop.

Step 7

Pulling from the bottom pull the loop tight(you can add a dab of glue for extra security).

Step 8

Trim the ends of the 1mm cord.

Step 9

Trim the 3 shorter ends of 3mm cord (this should be the under side of the bracelet).
DO NOT ALL 6.

Step 10

Repeat steps 1-9 on the other side, but this time trim 3x 45cm lengths of 3mm cord (2x 1 colour and 1 of the other).

Step 11

Trim the leather to fit your wrist and glue into clasp.