Egyptian Sphinx Bracelet
|1||Out of stock|
Some of the products required to make this item are either out of stock or no longer available.
|Total Cost||= £3.95|
Cut a piece of wire approx. 40cm long and thread on one part of the toggle clasp. Thread both ends through a crimp bead and attach to the clasp. Cover with a crimp cover.
Sort through your glass mix to make sure you have enough similar beads to complete your bracelet - each mix differs so it's best to check this before you start. Look for some matching pearls in around 8mm (I used 4 of these) and some matching pearls in around 4mm ( I used 12 of these).
Thread both ends of wire through an 8mm pearl. Now separate the ends and add a seed bead to each, followed by a 4mm pearl and a firepolished bead on each strand. Now thread one end through each of the holes on the pyramid bead.
Keeping the 2 ends separate, add the following beads to each: 1 pearl bead and 1 seed bead. Then bring the strands together and thread both through a firepolished bead. Separate the ends again and add 1 seed bead and 1 pearl bead to each strand before threading on the pyramid bead.
Repeat step 4 another 3 times but vary the beads if you wish. You will need to add the seed beads to make sure you don't see any of the wire as you bring the 2 pieces together.
After the 5th pyramid bead add the following beads to each strand: 1 1 x firepolished bead, 1 x 4mm pearl, 1 seed bead. Now bring the strands together and thread through an 8mm pearl. Crimp to the other side of the clasp and cover with a crimp cover.
Make sure you get the materials you need to create this design yourself! Click the button below to add everything you need to your basket in one go. You can edit the list too just in case you want to make more than one, or you already have some supplies at home.Get the items you need to make this