Cupchain Gold Bracelet
Products used in project:
Cupchain Gold Bracelet
Not all products are available for this project
Information about project:
Cupchain Gold Bracelet
Designed by: Laura
Difficulty: Intermediate
Tutorial on how to make this stunning cupchain and flat leather bracelet.
Step 1
Cut a piece of cupchain approx. 11.5cm (11 crystals) and a piece of suede cord approx. 50cm.
Step 2
Tie the suede cord onto the cupchain, leaving approx. 1.5cm at the beginning. Wrap the cord around the cupchain, making sure there are two wraps in each gap between the crystals.
Step 3
Knot the cord at the end and leave approx. 1.5cm of cord.
Step 4
Cut two pieces of flat eco nappa leather measuring approx. 14cm. Glue them into one of cord ends side by side.
Step 5
Cut two pieces of flat eco nappa leather measuring approx. 14cm. Glue them into one of cord ends side by side.
Step 6
Carefully glue the suede wrapped cupchain on to the centre of the 2 pieces of flat eco nappa leather. Glue each end of the suede cord into the cord ends and then securing the cupchain with little daps of glue where needed.
Step 7
For the clasp cut 2 pieces of approx. 15cm. Tie the pieces onto each cord ends, so you have two strands coming off each
Step 8
Thread the ends of the suede cord through the holes on the 3 hole slider, this may take some wiggling!
Step 9
Use this slider to tighten the bracelet on your wrist.
What our Happy Customers Have To Say
"Fantastic"
Carol Richardson
November 18th 2020
"I think Beads Direct is Great."
Roz
November 15th 2020
"I think they are great, reliable, quick and very helpful"
Christine
November 11th 2020