Crystal in Bloom Jewellery Set
Products used in this project
Not all products are available for this project
Information about this project
This design is now in our inspirations archive. As this design was created some time ago we sadly no longer stock all the products to create our design, but can still be useful for inspiration.
Crystal in Bloom Jewellery Set - Margot Potter for BeadsDirectUK
Lovely Lucite flowers in a panoply of pastels dance and swing around the neck, wrists and ears while prisms of light refract from faceted SWAROVSKI ELEMENTS in this decidedly feminine, flirty and (retro)fabulous design. Inspired by the chain and charm costume jewelry necklaces popular in the 1930s, Author and Designer Margot Potter adds a new twist with copper wire and findings to a lovely effect. All of the components to make this simply stunning jewelry set can be found at BeadsDirectUK.
Each large Lucite flower has a headpin threaded into the center with a smaller flower and a 5mm crystal. The colors are arranged as you wish; this is meant to be an intuitive process. Create a coiled and looped dangle at the back of the flower.
Grasp wire tail with round nose pliers. Bend to a 90 degree angle. Wrap headpin over pliers until it can’t move further. Bend pliers ½ turn and finish loop. Bend pliers another half turn. Grasp wire tail with chain nose pliers, wrapping tightly around bottom of loop to top of bead, be gentle as you can break the flowers or crystals if you rush. Cut off excess wire and gently tuck tail into bottom of coil with chain nose pliers.
Gently press coiled loop flush to back of bead, this will allow the flower to hang flat facing forward when the necklace is worn. Repeat this for all of your large flowers. There are six on the bracelet, seven on the necklace and two matching flowers for earrings.
Make coiled top dangles with your small flowers. Thread a crystal on a head pin into the center of your bead. Make a coiled and looped dangle leaving the coil straight up and down so the flower will hang straight down from the chain. These are hung in groups of three. There are three on the earrings, eighteen on the bracelet and twenty four on the necklace.
To put it all together, attach a toggle clasp to the necklace ends, bar on one end and toggle on the other using jump rings opened and closed with two chain nose pliers. (Watch the Crafty Quickies Jump Ring video to learn how to properly open and close jump rings with tension, no one likes to lose their dangles.)
The dangles are attached every fourth link (three open links between each dangle.) For the necklace, begin from the center. Attach a large flower on the center link using a jump ring. Attach a group of three small flowers on jump rings on both sides of the flower skipping three links. Repeat alternating between large flowers and groups of small flowers until you have seven large flowers and eight groups of three small beads. (When attaching dangles to chains, be sure all dangles are falling from the bottom of each link group. Keep the necklace flat while working to ensure this.)
For the bracelet, skip the first four links and add three flower dangles, skip three and add a large flower and repeat alternating between large flowers and small flowers until you reach the sixth large flower.
Attach a toggle clasp to the bracelet ends as with the necklace before using jump rings.
To make the earrings, hang the smallest chain segments on a jump ring attached to the bottom of each ear wire, thread three beaded small flowers on each jump ring before securing closed. Attach a large flower to the bottom of each small chain segment using a jump ring.
Check back through the pieces to be sure all jump rings are properly closed. Toss on a pretty sundress, a cardigan, a pair of lace-up espadrilles and head off into the world feeling like the fabulous flower you are, Buttercup.
What our Happy Customers Have To Say
"Well done team. Customer service doesn't get any better than this."
April 22nd 2019
"Wow what service"
January 24th 2019
"I love Beads Direct."
January 21st 2019