Copper Blush Bracelet |

Copper Blush Bracelet

Products used in project:

Copper Blush Bracelet

Items (5)
Rose Gold Plated Swivel Lobster Clasp 12x5mm Pack 1
Out of stock
Nymo Beading Thread Size D 0.3mm Sand 64yards
Out of stock
Almond Matte Czech Glass Round Pearl Beads 4mm Pk120
Out of stock
Preciosa Pressed Glass Orion Beads Copper 3x5mm Pk30
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Copper Blush Bracelet

Designed by: Katrina

Difficulty: Beginner


Make a cute and simple bracelet using the new Preciosa Orion beads with Swarovski crystal chatons and glass pearls.

Step 1

Cut an arm span of Nymo thread and thread your needle onto one end. String on 11 seed beads to the centre of the thread. Thread a needle onto the other side of the thread and pass both needles through a single seed bead. Weave one of the threads back around the loop to make it more secure.

Step 2

String on a pearl, Orion bead, pearl until you have used 8 pearls, with 7 Orion beads in between. Finish on a pearl.

Step 3

String on 7 seed beads and pass the needle through one side of the connector and then back through the first bead you added. Weave the other side of the thread around the beaded loop to reinforce it. Pull the threads so that there are no gaps and weave the threads back into the design, tieing a few half-hitch knots along the way. When you are happy that your work is secure, trim away the tail threads.

Step 4

Repeat the steps to make the other half of your bracelet. In step 1, add your lobster clasp after the 6th seed bead.

Step 5

Apply a drop of glue to the connector and set your crystals into place. Allow to dry for up to 24 hours before wearing your finished bracelet.