Learn how to make these 'Blossom' Bracelets from the 'Summer Flora' Collection | beadsdirect.co.uk
0

Blossom 'Summer Flora' Bracelets

Products used in project:

Blossom 'Summer Flora' Bracelets

Items (9)
Qty
Price
Fevi Kwik One Drop Instant Adhesive/Glue 1g Tube
W311
1
Out of stock
Gold Plated Brass Round Lobster Clasp 13mm Pk1
F990
1
Out of stock
X Stretch Magic Elastic Bead Cord 0.5mm Clear 25m
TC480
1
Out of stock
Liberty of London Style Ribbon Flat Black/Red Mix 20mm 1m
TC0203
1
Out of stock
X-Gold Plated Iron Jumprings 4mm 0.8mm Thick Pk100
F0214
1
Out of stock
4470 Swarovski Crystal Square Fancy Stone 12mm Crystal Silver Night F Pk1
AC1254
1
Out of stock
Titanium Plated Flat Wire Round Bangle 63mm Pk1
CH399
1
Out of stock
Total Cost
£2.34

Not all products are available for this project

Information about project:

Blossom 'Summer Flora' Bracelets

Difficulty: Beginner

Rating:

Learn how to make these 'Blossom' Bracelets from the 'Summer Flora' Collection using Liberty of London Ribbon and a Swarovski Crystal.

Step 1

Ribbon Wrapped Bangle

Add a dab of Fevi Kwik glue onto the bangle base and attach the end of the ribbon to it. Hold in place for a minute, until dry. Continue to wrap the ribbon around the bangle until the bangle base is completely covered.You can continue to overlap the ribbon to make your bangle as thick as you like.

Trim ribbon and secure tightly using Fevi Kwik.

Step 2

Elastic Bead Bracelet

Thread on the desired amount of beads onto elastic (approx. 30). Trim elastic and tie securely using a double knot. You may wish to add a dab of glue to the knot for added security.

Step 3

Braided Swarovski Bracelet

1.  Cut 3 lengths of cord measuring 30cm each. Tie a knot close to the top. You may wish to attach this to a surface using a piece of cellotape. Begin to plait the cord until you reach the end. Knot again.

2.  Add a dab of Fevi Kwik onto the two bottom ends of your bracelet. Wait until dry and cut into a point. Slot into the cord ends. Attach the Swarovski connector using 2 jumprings and glue in your crystal. Repeat the ‘glue and point’ process on the other ends and attach the sterling silver cord ends with lobster.

3. Attach a jumpring onto one foldover to create the clasp. Attach a jumpring and a lobster clasp to the other end.