Create your curl shape with your thicker silver plated wire.
Carefully hammer your wire shape to flatten and strengthen the metal.
Repeat for your other earring.

Click here to get your Whammer Hammer.
Click here to get your steel block.

When you are happy with your curled shape, cut a length of thinner copper wire (approx. 10-15").
Place a little of your wire along the underside of your earring and tightly wrap around this to secure it there at your starting point.
Tightly wrap 4/5 times around your earring leaving approx. 1mm between each wrap.
Thread on a pearl bead and position it on your wire on the front of the earring.
Repeat your wire wrapping.
You will be able to slightly alter the position of your pearls after you place them.
Carry on wrapping and adding pearls until you have covered your earring.

Finish your wire by wrapping tightly around the last wrapped sections.
You could also tuck in your wire to hide the end.
Trim your wire close to the back of the earring and spend time squashing it flat with pliers, do the same with your starting point wire.
Repeat for your second earring.