Black Sparkle Ring
Products used in project:
Black Sparkle Ring
Not all products are available for this project
Step 1
Wrap your aluminium wire 3 times around your chosen ring shaper (you can use anything tubular that is the right size for your finger) leaving an end of approx. 3cm at one end, and the coiled wire at the other. Wrap the end of wire around 2-3 times to hold everything together. Snip off any excess wire if necessary.
Step 2
Snip around 10cm of silver wire and thread on a bead. Holding the bead close to the wire ring base, wrap each end of silver wire around the base. Position the bead where you would like it on the ring, and then start to wrap the thick wire around it.
Step 3
After a few wraps, add another bead and wrap the wire around this bead and the one you added before. Keep adding beads and wrapping in this way. You can stop after just a few beads if you’d like a simple ring. When you’re happy with the size of your ring, post the end of the wire through the middle of the ring and pull it out through a gap in the beads and snip off any excess wire.
What our Happy Customers Have To Say
"Excellent service friendly and fast delivery. Good products at reasonable prices and love the 50 for 50 offers. Wonderful company with excellent products and customer service"
CAS
May 2nd 2022
"Beads direct are brilliant. I have bought from other companies but I always come back to Beads Direct. The range is almost endless, customer service cannot beaten, delivery is super quick and when the beautifully packaged parcel arrives - it is like a gift. Yes, you could safely say I like this company very much :)"
Sharon Rushen
May 2nd 2022
"Absolutely brilliant service very fast delivery can't fault any product."
Kim
April 21st 2022