Black and Gunmetal Hematite Bracelet
Products used in project:
Black and Gunmetal Hematite Bracelet
Not all products are available for this project
Information about project:
Black and Gunmetal Hematite Bracelet
Designed by: Leah Connolly
1x Black Waxed Nylon Cord 1.5mm [TC376]
1x Faceted Gunmetal Hematite 10mm [EX12]
1x Onyx Matt Hematite 10mm [EX2649]
STEP 1: Cut approx. 40cm of the Shamballa cord an tie a knot at one end, then tie another knot approx. 10cm below that.
STEP 2: Cut approx. 1m more Shamballa cord and start your square knots. Do two complete macramé square knots and thread on a bead. If you have not tied a square knot before please watch our tutorial video.
STEP 3: Do two complete knots, knotting around the bead. Now thread on another bead and tie two complete knots. Continue adding the beads until all 7 have been added.
STEP 4: Do two complete knots and then knot or burn with a thread zapper. Leave a 10cm gap and then tie a knot, trim any excess cord.
STEP 5: Cut approx. 60cm of cord and create a sliding knot over the base cords. Trim any excess cords by either knotting them or using a thread zapper.
What our Happy Customers Have To Say
"Beads Direct is a wonderful supplier, the staff are fantastic, knowledgeable, friendly, super helpful and extremely efficient, reliable and honest."
Roz
October 9th 2019
"Just used my new kumihimo handle and weighted bobbins and they are great. My kumihimo has never been so neat and the thread/ weave so tight. It's great."
Rosie
September 25th 2019
"Fab company"
Sue M
August 13th 2019
