Tutorial on how to make this 'Becharmed Blackberry' bracelet with other Swarovski elements. | beadsdirect.co.uk

Becharmed Blackberry Bracelet

Products used in project:

Becharmed Blackberry Bracelet

Items (4)
Kumihimo Braiding Disk Round 6 Inch Pk1
Out of stock
Fevi Kwik One Drop Instant Adhesive/Glue 1g Tube
Out of stock
Kumihimo No Tangle Thread Bobbins Pk8
Out of stock
S-Lon Bead Cord 77yrds (70m) Black
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Becharmed Blackberry Bracelet

Difficulty: Expert


Follow the tutorial on how to make this Becharmed Blackberry bracelet using Swarovski Elements too. If you have not created a kumihimo braid before you will also need: Kumihimo braiding disk No Tangle Bobbins, Needle, thread

Step 1

Cut 8 strands of s-lon cord approx. 50cm long. Tie all the threads together in a loose knot in the centre. Thread on the Becharmed bead.

Step 2

Place the knot through the centre of the kumihimo braiding board. Let the ends dangle down, the knot underneath the Becharmed bead should keep it in place.

Step 3

Set up the kumihimo board for a normal 8 strand braid (one strand either side of each dot). If you haven't created an 8 strand braid before, see the related videos below to learn how.

Step 4

Thread 11 crystal lilac shadow round beads on one strand and knot to keep in place (as the strands are quite short I found a knot worked better than a bobbin). Repeat until you have 11 crystal lilac shadow beads on the strands either side of the top and bottom dot. Now move to the strands that go out to the side dots and thread 11 pearls on each, then knot. You may need to use a bead reamer to ensure the s-lon passes smoothly through the pearls.

Step 5

Start braiding, using each strand once without any beads to begin (this should sit inside your Becharmed bead). Now start adding your beads, adding a bead to every strand. If you haven't added beads to a braid before see our related videos below.

Step 6

Braid until you have used all the beads. Create 0.5-1cm unbeaded braid, then knot all the threads together.

Step 7

Place your beaded section down through the kumihimo disk. Set up for braiding as before, threading on beads in the same way. Braid in the same way as the other side.

Step 8

You should now have 2 beaded sections with the Becharmed bead in the centre. Make sure the knots at the end are tight, and the unbeaded braid and knot will be hidden inside your clasp. If necessary adjust the knot to ensure a tidy finish. Glue the ends into each end of the clasp. As the clasp is larger than the s-lon braiding, the knots will help it to adhere.