Aurora Ice Bracelet Project in Blue | Beads Direct

Aurora Ice Bracelet in Blue

Products used in this project

Items (6)
1028 Swarovski Xilion Chaton SS39 8mm Aquamarine F Pk2
Out of stock
"X" 1088 Swarovski Xirius Chaton SS39 8mm Blue Zircon F Pk2
Out of stock
X Waxed Cotton Cord 1mm Navy Blue 5metres
Out of stock
1088 Swarovski Xilion Chaton SS39 Fuchsia F Pk2
Out of stock
Total Cost

Not all products are available for this project

Information about this project

Difficulty: Intermediate


bracelet instructions

Want to make the Aurora Ice bracelet in purple? Go on, give it a go follow this link to find out how.
Or you could make it in copper. See the Aurora Ice Bracelet in copper

Step 1

Place a Swarovski Elements Chaton into the first cup of the bracelet setting. When in place, use pliers to close the teeth on the setting. Repeat until you have added a crystal chaton to each setting cup.

 Please note: glue is not necessary, but you could add a dab behind the crystal for an extra secure finish.

Step 2

Lay the cupchain bracelet next to the curb chain. Remove any excess chain links to make the curb chain the same length as the cupchain bracelet.

Step 3

Cut approx. 2m of waxed cotton cord and tie next to the clasp on the cupchain bracelet. Now thread the end of the cord up through the first link of the curb chain, over the top of the cupchain between the first two cups and up through the second link of curb chain. Repeat this until you reach the end of the bracelet.

Step 4

Tie the waxed cotton cord to secure then repeat step 3 in the opposite direction, creating a cross with the cord.

Step 5

Tie the waxed cotton cord to secure at the end. Cut off any excess cord.