Learn how to make this stunning 5 strand 'Angel Dark' bracelet | beadsdirect.co.uk

Angel Dark Bracelet

Products used in project:

Angel Dark Bracelet

Items (5)
X- Essential Crystal Faceted 6mm Rondelle Jet AB 100pack
Out of stock
1088 Swarovski Xirius Chaton SS39 8mm Crystal AB F Pk2
Out of stock
Antique Silver Zamak 5 Strand Fancy Clasp 39mm 1xPair
Out of stock
1088 Swarovski Xilion Chaton SS39 Jet Pk2
Out of stock
Total Cost

Not all products are available for this project

Information about project:

Angel Dark Bracelet

Difficulty: Intermediate


Dark Angel Bracelet


If you would like your bracelet to look exactly like this one, follow the pattern from the picture above.

If you already have silver jumprings in your own stash, you may want to take them out your shopping basket at the check out. 

Step 1

How to make the cupchain section

Place a Swarovski Elements Chaton into the first cup of the bracelet setting. When in place, use pliers to close the teeth on the setting. Please note: glue is not necessary for adding the chatons, but you could add a dab behind the crystal for an extra secure finish. Add a spike bead after every 2 crystals by gluing in to the cup. Repeat until you have added a crystal chaton or a spike to each setting cup.

Step 2

Repeat step 1 to fill another bracelet setting. Remove the clasp and extender chain from either end of each bracelet and attach your crystal cupchain bracelets to one of the loops on your spacer bar.

Step 3

How to make the other strands

Attach a 25cm piece of wire to 3 of the other loops using a crimp bead. Alternatively create 3 loops using crimp beads and attach using a small jumping.

Step 4

Thread on your rondelle beads and your preciosa gumdrop beads to each wire to match the length of the crystal set section you have already added. Crimp at the other end to secure and attach a jumpring if necessary.

Step 5

Attach the toggle clasp to both ends using a larger jumpring